Save up to $300.65!

Everything Is Solar EPever 10A 20A 30A MPPT Dual Battery Charge Controller DR1206N DR2210N DR3210N DuoRacer Series Solar Panel Charger Regulator DDS

(1 customer review)

$120.93$184.28

Clear
Add to Wishlist
Add to Wishlist

Everything Is Solar EPever 10A 20A 30A MPPT Dual Battery Charge Controller DR1206N DR2210N DR3210N DuoRacer Series Solar Panel Charger Regulator DDS

Everything Is Solar™

 

  • Free shipping available on this item with coupon code:  EverythingIsSolar at checkout
  • Mastercard and Visa credit/debit cards accepted through PayPal checkout with CoinPayments
  • Please allow 1 – 3 days for order processing and allow 2 – 4 Weeks for delivery
  • Please understand our Terms and Conditions for refunds at:  https:/houseofinternationaldecor.com/return-policy

 

 

DuoRacer MPPT charge controller is made for charging two batteries (shown as BATT1 and BATT2 below) at the same time in a solar system. This controller supports multiple life battery (BATT1) types, including Sealed, Gel, Flooded, LiFePO4, and Li-NiCoMn, which is suitable for RV, Camper, Boat, and so on. The device recognizes the start battery (BATT2) system voltage automatically, and trickle charges the battery when the conditions are satisfied.

The controller adopts the advanced MPPT control algorithm,which will minimize themaximum power point loss rate and loss time,also fast track the maximum power point(MPP) of the PV array, and obtain the maximum energy from solar array under any conditions. The energy utilization in the MPPT solar system is increased by 20-30% compared with PWM charging method.

When there is no manual operation for a long time, and the charging conditionscannot be reached, the controller will turn to low-power mode, which reduces the loss and battery power waste to enhance the products life. The system parameters are shown and set by LED/LCD or the MT11 remote meter (Accessory).The AES control signal of the car refrigerator is built in the controller, which will supply the surplus solar power to the refrigerator to avoid energy waste. The controller comes with IP33 protection level, which is waterproof and dustproof. Multiple protection features, including battery overcharge protection, over discharge protection, and reverse connection protection of the PV and battery, which effectively ensure the
solar system safety, stability, and lifetime.
Maximum Power Point Tracking technology with ultra-fast tracking speed and the tracking efficiency is no less than 99.5% guaranteed

Advanced MPPT control algorithm to minimize the MPPlost rate and lost time

The wider range of the MPP operation voltage to improve the PV module utilization

Auto control function of charging power & charging current limitation(BATT1)

High quality and low failure rate components of ST, TI and Infineon to ensure the product life

Digital circuit control of adaptive three-stage charging mode to enhance BATT1 life.

BATT1 type can be set via LED/LCD.

Product runs into the low-power mode when there is no manual operation for a long time, and charging conditions are not satisfied (PV<5V).

100% charging and discharging in operationenvironmental temperature range.

LED and LCD dispiay units selectable.

AES control signal for car refrigerator to avoid energy waste.

Standard Modbus protocol, and RS485 (5V/200mA) communication port for the customer to expand the application area.

Life battery (BATT1) is the energy storage battery for powering the household loads in the off-grid system, which supports Sealed, Gel, Flooded, LiFePO4, and Li-NiCoMn batteries(the controller can NOT recognize the system voltage automatically).

Start battery (BATT2) is the energy storage battery which usually built in the vehicle for powering the system such as RV and Boat, and only supports lead-acid battery (the controller will recognize the system voltage automatically).

NOTE: the BATT1 and BATT2 must be at the same voltage level.

ItemDR1206N-DDSDR2210N-DDSDR3210N-DDS
BATT1 rated voltage12/24VDC
BATT2 rated voltage12/24VDC Auto
Rated Charge Current10A20A30A
Battery Input Voltage Range8.5~32V
Max. PV Open Circuit Voltage60V100V
Rated Charge Power130W/12V260W/12V390W/12V
260W/24V520W/24V780W/24V
Max. Conversion efficiency97.4%97.5%98%
Full load efficiency97%96%96%
Self-consumption12mA/12V;8mA/24V 4mA/12V;3mA/24V(Low-power mode)26mA/12V;15mA/24V 19mA/12V;10mA/24V (Low-power mode)
GroundingCommon negative
BATT2Full voltage13.8V/12V;27.6V/24V(default)
BATT2 Charge return voltage13V/12V;26V/24V(default)
AES signal port5VDC/Max.200mA(2*(3.81-4P))
RS485 com. port
Com. baud rate115200(default)
LCD backlight time60S(default)
EnclosureIP33
Dimension227.2×143×58.1mm243.7×158×63mm247.2×165×68.5mm
Mounting dimension160×134mm180×149mm180×156mm
Mounting hole size5mm
Terminal12AWG/4mm 2 (BATT1)6AWG/16mm 2 (BATT1)6AWG/16mm 2 (BATT1)
12AWG/4mm 2 (BATT2)12AWG/4mm 2 (BATT2)12AWG/4mm 2 (BATT2)
Recommended cable size12AWG/4mm 2 (BATT1)10AWG/6mm 2 (BATT1)8AWG/6mm 2 (BATT1)
12AWG/4mm 2 (BATT2)12AWG/4mm 2 (BATT2)12AWG/4mm 2 (BATT2)

Brand Name

EPever

Model Number

DR1206N-DDS/DR2210N-DDS/DR3210N-DDS

is_customized

Yes

Application

Solar Working Station

Maximum Current

MPPT 30A 20A 10A

BATT1 rated voltage

12/24VDC Sealed, Gel, Flooded, LiFePO4, Li-NiCoMn

BATT2 rated voltage

12/24VDC Auto lead-acid battery (Only)

Max. PV Open Circuit Voltage

DR1206N-DDS(60V) 100V(DR2210N-DDS DR3210N-DDS)

Grounding

Common negative

Output Port

RS485 and AES Port

LCD

Backlight LCD Display

Max. conversion efficiency

98%

Item

EPever 10A 20A 30A MPPT Dual Battery Charge Controller

1 review for Everything Is Solar EPever 10A 20A 30A MPPT Dual Battery Charge Controller DR1206N DR2210N DR3210N DuoRacer Series Solar Panel Charger Regulator DDS

  1. V***s

    Uncle

Add a review

Your email address will not be published. Required fields are marked *